Previously, an error JSON fragment would look like:
{"message_type": "error", "error": {}}
This is because encoding/json cannot marshal an error interface.
Instead, we now call .Error() to get the string value.
To clear the status lines, they should be set to an empty array to
prevent future updates of those lines. Setting the status lines to an
array containing an empty string is wrong as this causes the output to
continuously add that empty status line after each message.
The ETA restic displays was based on a rate computed across the entire
backup operation. Often restic can progress at uneven rates. In the worst
case, restic progresses over most of the backup at a very high rate and
then finds new data to back up. The displayed ETA is then unrealistic and
never adapts.
Restic now estimates the transfer rate based on a sliding window, with the
goal of adapting to observed changes in rate. To avoid wild changes in the
estimate, several heuristics are used to keep the sliding window wide
enough to be relatively stable.
Added missing call to scanFinished=true.
This was causing the percent and eta to never get
printed for backup progress even after the scan was finished.
The StdioWrapper is not used at all by the ProgressPrinters. It is
called a bit earlier than previously. However, as the password prompt
directly accessed stdin/stdout this doesn't cause problems.
The status bar got stuck once the first error was reported, the scanner
completed or some file was backed up. Either case sets a flag that the
scanner has started.
This flag is used to hide the progress bar until the flag is set. Due to
an inverted condition, the opposite happened and the status stopped
refreshing once the flag was set.
In addition, the scannerStarted flag was not set when the scanner just
reported progress information.
The channel-based algorithm had grown quite complicated. This is easier
to reason about and likely to be more performant with very many
CompleteBlob calls.
When backing up many small files, the unbuffered channels frequently
cause the FileSaver to block when reporting progress information. Thus,
add buffers to these channels to avoid unnecessary scheduling.
As the status information is purely informational, it doesn't matter
that the status reporting shutdown is somewhat racy and could miss a few
final updates.
